Filter
Top Products
STEP 3 (See Diagram 3)
A.) Attach the Backrest Incline Support (#12) in between the two side-holes on the
Backrest Supports (#17). Attach the Backrest Supports to the pivot on the Main Seat
Support (#4). Secure it with one M12 x 7 ½” Allen Bolt (#53), two ∅ 1” Washers (#60),
and one M12 Aircraft Nut (#45).
B.) Place the other end of Backrest Supports rest against the Backrest Adjustment Bar.
C.) Place the Backrest Board (#21) onto the Backrest Supports (#17). Secure it with four
M8 x 1 5/8” Allen Bolts (#54) and Ø 5/8” Washers (#58).
D.) Attach the Leg Developer (#6) to the Leg Developer Holder (#5). Secure it with one
Axle (#28), two M10 x 1” Allen Bolts (#52), and two Ø ¾” Washers (#59).
E.) Insert two Foam Tubes (#18) halfway through the holes on the Leg Developer. Push
four Vinyl Foam Rolls (#32) onto the Tubes. Push four Foam Roll End Caps (#39) into
the Tubes from both ends.
F.) Attach a Short Olympic Sleeve (#34) to the weight post on the Leg Developer. Attach a
Spring Clip (#27) to the Sleeve.
G.) Attach the Curl Bar Handle (#9) to the bracket on the Leg Developer. Secure it with a
L-shaped Lock Pin (#26).
H.) Attach the Arm Curl Pad (#20) to the Arm Curl Stand (#7). Secure it with two M8 x 5/8”
Allen Bolts (#55) and Ø 5/8” Washers (#58). Insert the Arm Curl Stand into the opening
on top of Leg Developer Holder. Secure it with the Lock Knob.
I.) Remove the Arm Curl Stand and Curl Bar Handle when doing Leg exercises.
9