Filter
Top Products
STEP 5 (See Diagram 5 & Cable Loop Diagram)
A.) Attach the 330” Upper Cable (#51) to the swivel pulley pre-installed in the front of
the Right Lat Bar Frame (#9). Install a Ball Stopper (#46) onto the end of the
Cable. Attach the U-shaped Connector (#28) to the end of the Cable.
B.) Attach a Short Chain (#30) in between the openings on the Connector and secure it
with a M10 x 1 3/8” Allen Bolt (#62), two ∅3/4” Washers (#67), and one M10
Aircraft Nut (#69).
C.) Draw the Cable over the Pulley and pull through the Cable sleeve on the Right Lat
Bar Frame. Draw the Cable along the Frame towards the back of the machine to
the Pulley previously installed. Draw the Cable around the Pulley then downward to
the Double Floating Pulley Bracket (#24).
D.) Attach two Pulleys (#36) to the Bracket. Secure them with a M10 x 2 ¾” Allen Bolt
(#59), two Ø ¾” Washers (#67), and one M10 Aircraft Nut (#69).
E.) Draw the Cable around the back Pulley then upward to the open bracket on the
bottom of the Lat Bar Frame Bracket (#20). Install another Pulley.
F.) Draw the Cable around the Pulley then back down to the Double Floating Pulley
Bracket (#24) again. Let the Bracket hanging for now.
G.) Draw the Cable around the front Pulley then upward towards the Pulley on the Left
Lat Bar Frame (#10).
H.) Draw the Cable over the Pulley then along the Left Lat Bar Frame (#10) towards
the front of the machine. Insert the Cable through the Cable sleeve and over the
pre-installed Pulley on the front of the Left Lat Bar Frame.
I.) Install a Ball Stopper (#46) at the end of the Cable and attach a U-shaped
Connector (#28) to the end. Attach a Short Chain (#30) in between the openings
on the Connector and secure it with a M10 x 1 3/8” Allen Bolt (#62), two ∅3/4”
Washers (#67), and one M10 Aircraft Nut (#69).
J.) Connect the Lat Bar (#11) or Single Handles (#33) to the Short Chains using C-
clips (#32).
10