Filter
Top Products
STEP 2 (See Diagram 2)
A.) Connect the Upper Tension Connector (#6) from the Computer Post (#4) to the Lower
Tension Connector (#7) from the Main Frame (#9). Slide the cable wire from the
Upper Tension Connector (#6) in between the opening on the wire holder on the Lower
Connector (#7). Pull the Upper Tension Connector upward and slide the wire through
the slot on the bracket then drop it down so the fitting sits firmly on the bracket (See
How To Connect Tension Connector on next page).
B.) Connect the Upper Sensor Wire Connector (#3) from the Computer Post to the Lower
Sensor Wire Connector (#8) from the Main Frame.
C.) Hide all the wires inside the post. Slide the Computer Post (#4) into the Main Frame
(#9). Secure it with one M8 x 5/8” Allen Bolt (#20) and ∅ 7/8” Washer (#22).
D.) Connect the Computer Sensor Wire (#31) to the Upper Sensor Wire Connector (#3).
Hide the wires inside the post. Attach the Computer (#1) to the Computer Post.
Secure it with four M5 x 3/8” Philips Screws (#2).
DIAGRAM 2
5