Filter
Top Products
STEP 2 (See Diagram 2)
A.) Attach a Front Vertical Frame (#6) to the Right Base Frame (#2). Secure it with
two M10 x 2 ¾” Carriage Bolts (#77), Ø ¾” Washers (#87), and M10 Aircraft Nuts
(#88). Do not tighten the Nuts and Bolts yet.
B.) Repeat Procedure A above to install the other side.
C.) Connect the two Front Vertical Frames (#6) with an Upper Frame (#10) on the top.
Secure each end with two M10 x 3 ½” Carriage Bolts (#75), Ø3/4” Washers (#87)
and M10 Aircraft Nuts (#88).
D.) Insert a Guide Rod (#7) into the “Ring” on the Right Base Frame (#2). Secure it
with a M8 x 3/8” Screw (#82).
E.) Slide a Lower Safety Catch (#96) onto the Guide Rod (#7).
F.) Slide an Ø 2 ½” Rubber Bumper (#57) onto the Rod.
G.) Slide a Safety Stop Frame (#9) onto the Rod.
H.) Attach the top of the Guide Rod (#7) to the “Ring” on the Upper Frame (#10) and
secure it with a M8 x 3/8” Screw (#82).
I.) Repeat the above Procedures D through H to install the other side.
J.) NOTE: Help of another person for this step is strongly recommended. Place the
Lifting Sleeve (#12) in between the two Safety Stop Frames (#9). Align the holes
and insert the Weight Bar (#11) into the Safety Stop Frame from one side and
through the Lifting Sleeve to the other Safety Stop Frame on the opposite side.
Secure the Weight Bar to each Safety Stop Frame with one M8 x 5/8” Allen Bolt
(#80).
K.) Turn the safety hook forward on the Lifting Sleeve (#12) into the selected holes on
the Front Vertical Frame to secure its position.
L.) Slide an Ø 3” Rubber Bumper (#55) onto each end of the Weight Bar. Attach the
Long Olympic Sleeve (#62) onto each end of the Weight Bar. Secure each Sleeve
to the Bar with one M8 x ½” Allen Bolt (#79).
M.) Attach a Spring Clip (#39) to each Olympic Sleeve.
N.) Insert Right & Left Short Safety Catches (#92 & #94) and the Right & Left Long
Safety Catches (#93 & #95) into the selected holes on the Front Vertical Frames.
O.) Securely tighten all Nuts and Bolts previously installed.
7