Filter
Top Products
STEP 6 (See Diagram 6 & Cable Loop Diagram)
A.) Insert the 242” Upper Cable (#35) through the swivel pulley bracket pre-installed in the top
front of the Right Lat Bar Frame (#17).
B.) Install a Ball Stopper (#86) onto the end of the Cable. Attach a U-shaped Connector (#91) to
the end of the Cable.
C.) Attach a Short Chain (#40) in between the opening on the Connector and secure it with a M10
x 1 3/8” Allen Bolt (#72), two Ø ¾” Washers (#87), and one M10 Aircraft Nut (#88).
D.) Draw the Cable over the Pulley and pull through the Cable sleeve on the Right Lat Bar Frame.
Draw the Cable along the Frame towards the back of the machine to the Pulley previously
installed. Draw the Cable around the Pulley then downward to an Angled Floating Pulley
Bracket (#28).
E.) Attach two Pulleys (#45) to the Bracket. Secure them with one M10 x 2 ¾” Allen Bolt (#68),
two Ø ¾” Washers (#87), and one M10 Aircraft Nut (#88).
F.) Draw the Cable around the back Pulley then upward to the open bracket underneath the Lat
Bar Frame Bracket (#15). Attach a Single Pulley Bracket (#98) to the bracket. Secure it with
one M10 x 1 3/8” Allen Bolt (#72), two Ø3/4” Washers (#87), and one M10 Aircraft Nut (#88).
Attach a Pulley to the Bracket. Secure it with one M10 x 1 ¾” Allen Bolt (#71), two Ø ¾”
Washers (#87), and one M10 Aircraft Nut (#88).
G.) Draw the Cable around the Pulley then back down to the Angled Floating Pulley Bracket (#28)
again. Let the Bracket hanging for now.
H.) Draw the Cable around the front Pulley then upward towards the Pulley on the Left Lat Bar
Frame (#16).
I.) Draw the Cable over the Pulley then along the Left Lat Bar Frame towards the front of the
machine. Insert the Cable through the cable sleeve and over the pre-installed Pulley on the
front of the Left Lat Bar Frame.
J.) Repeat the Procedures B & C above to install a Ball Stopper, U-shaped Connector, and a
Short Chain.
K.) Connect the Lat Bar (#22) or Single Handles (#59) to the Short Chains using C-clips (#42).
13