Filter
Top Products
STEP 4 (See Diagram 4)
A.) Place Backrest Board (#24) onto Backrest Supports (#22). Secure it with four
M8 x 1 5/8” Allen Bolts (#35) and ∅ 5/8” Washers (#34).
B.) Place Seat (#25) onto the Seat Bracket (#19). Secure the two back holes with
two M8 x 5/8” Allen Bolts (#33) and ∅ 5/8” Washers (#34). Secure the two
front holes with a Seat Incline Adjustment (#18), two M8 x 5/8” Allen Bolts
(#33) and ∅ 5/8” Washers (#34). Insert a L-shaped Pin (#29) into the
selected hole on the Seat Incline Adjustment to hold the desired incline.
C.) Insert one Foam Roll Tube (#30) halfway through the hole on the Leg
Developer Holder. Insert two Foam Roll Tubes (#30) halfway through the
holes on the Leg Developer (#17). Push six Foam Rolls (#31) onto the Tubes
from both sides.
D.) Attach the Arm Curl Pad (#23) to the Arm Curl Stand (#26). Secure it with two
M8 x 5/8” Allen Bolts (#33) and ∅ 5/8” Washers (#34). Insert Arm Curl Stand
into the square opening on Upright Beam. For Arm Curl exercise, remove Leg
Developer and insert Arm Curl Stand into the opening on top of Front
Stabilizer.
E.) Attach two Spring Clips (#32) onto both ends of Curl Bar (#27). Insert the Curl
Bar into the round opening on the Upright Beam.
DIAGRAM 4
7