Filter
Top Products
ASSEMBLY INSTRUCTION
Tools Required to Assemble the Machine: Two Adjustable Wrenches, two Allen
Wrenches, and one Flat Head Screwdriver
NOTE: It is strongly recommended two or more people assembling this machine to
avoid possible injury.
STEP 1 (See Diagram 1)
A.) Connect the Main Base Frame (#2) and Front Base (#3) to the Front Stabilizer (#5).
Align the holes then secure them with two 3/8” x 3” Carriage Bolts (#69), ∅ 3/8”
Washers (#77), and 3/8” Aircraft Nuts (#74).
B.) Attach the Rear Stabilizer (#1) to the Main Base Frame. Secure it with one Bracket
(#26), two 3/8” x 3” Carriage Bolts (#69), ∅ 3/8” Washers (#77), and 3/8” Aircraft Nuts
(#74).
C.) Attach the Vertical Beam (#4) to the Main Base Frame (#2). Secure it with two 3/8” x 3”
Carriage Bolts (#69), ∅ 3/8” Washers (#77), and 3/8” Aircraft Nuts (#74).
D.) Over the two holes on the Rear Stabilizer (#1), stack up two Round Rubber Bumpers
(#40), two Guide Rod Sleeves (#7), then two Round Rubber Bumpers (#40) in
sequence. Align the holes then insert two Guide Rods (#13) all the way down into the
Rear Stabilizer (#1).
E.) Slide the Weight Holder (#8) from the top onto the two Guide Rods.
F.) Place the Upper Frame (#6) onto the Vertical Beam (#4) and the two Guide Rods (#13).
Secure the Upper Frame to the Guide Rods with two 3/8” x 1” Allen Bolts (#63) and ∅
3/8” Washers (#77). Secure the Upper Frame to the Vertical Beam (#4) with two 3/8” x
3” Carriage Bolts (#69), ∅ 3/8” Washers (#77), and 3/8” Aircraft Nuts (#74).
G.) Attach the Olympic Sleeves (#44) to the Weight Holder (#8). Attach the ∅ 2” Spring
Clips (#48) onto the Olympic Sleeves. Please note that we also provided two ∅1”
Spring Clips in case the ∅1” standard plates were used.
H.) Carefully tip over the machine to its side. Secure the bottom of the two Guide Rods to
the Rear Stabilizer (#1) with two 3/8” x 1” Allen Bolts (#63) and ∅ 3/8” Washers (#77).
8