Filter
Top Products
STEP 2 (See Diagram 2)
A.) Slide 14 Weight Plates (#33) onto the Guide Rods. Make sure the deep groove
on the Weight Plates all facing the front of the machine and downward. Insert the
Selector Rod (#28) through the center hole on the Weight Plates. Slide the
Selector Stem (#32) onto the Guide Rods. Use the L-shaped Pin (#39) to select
total weights to exercise. Please refer to the Weight Resistance Chart in page 22.
B.) Place the Upper Frame (#5) onto the Vertical Frame (#4). Secure them with one
M10 x 2 ¾” Allen Bolt (#75), two Ø ¾” Washers (#80), and one M10 Aircraft Nut
(#82) from the side. One M10 x 2 ¾” Allen Bolt (#75), one 1 7/8” Square Bracket
(#25), two Ø ¾” Washers (#80), and one M10 Aircraft Nut (#82) from front.
C.) Attach the holes on the Top Socket Assembly (#6) onto the two Guide Rods (#7).
Secure it with two M10 x 1” Allen Bolts (#71) and two Ø ¾” Washers (#80).
D.) Attach the other end of Top Socket Assemble to the Upper Frame. Secure it with
one M10 x 2 ¾” Allen Bolts (#75), one M10 x 2 ½” Allen Bolt (#74), two Ø ¾”
Washers (#80), one 4” x 2” Bracket (#24), one Ø ¾” Washer (#80), and one M10
Aircraft Nuts (#82).
E.) Attach the Weight Stack Cover (#27) to Rear Base Frame (#2) and Top Socket
Assembly. Secure it with four M10 x 5/8” Allen Bolts (#70) and four Ø ¾” Washers
(#80).
F.) Securely tighten all Nuts and Bolts previously installed in Sept-1 and Step-2.
10