Filter
Top Products
STEP 7 (See Diagram 7 & Cable Loop Diagram)
A.) Attach the 142” Lower Cable (#28) to the opening on the bottom of the Leg
Developer (#10).
B.) Attach a Pulley (#38) to the opening. Secure it with one M10 x 2 3/8” Allen Bolt
(#64), two ∅ 1” x ½” Pulley Bushings (#39), and one M10 Aircraft Nut (#72).
C.) Draw the Cable underneath the Pulley towards the back of the machine to the
opening on the bottom of Vertical Frame (#3).
D.) Repeat Step B to install a Pulley.
E.) Pull the Cable upward to the Angled Double Floating Pulley Brackets (#18)
previously installed in Step-6.
F.) Attach a Pulley to the Bracket. Secure it with one M10 x 1 ¾” Allen Bolt (#63),
two Ø ¾” Washers (#70), and one M10 Aircraft Nut (#72).
G.) Draw the Cable around the Pulley then pull downward to the open bracket on the
Main Base Frame (#1). Repeat Step F to install a Pulley.
H.) Draw the Cable around the Pulley then pull upward to the Pulley on Double
Floating Pulley Bracket (#20) previously installed in Step-5.
I.) Draw the Cable around the Pulley then pull downward to the bracket on the rear
of Vertical Frame. Secure the other end of the Chain to the bracket with a M10 x
1” Allen Bolt (#62), two ∅ ¾” Washers (#70) and one M10 Aircraft Nut (#72).
J.) Adjust the tension of the Cable System by adjusting the position of the Pulley on
the bottom half of the hanging bracket (multi-holes). If the Cables are too loose
then move the Pulley up one hole on the Double Floating Pulley Bracket. If the
cable tension is too tight, move the pulley down one hole on the bracket.
K.) Attach the 15-link Chain (#29) to the end of the Cable by using a C-clip (#31).
Attach the Arm Curl Handle (#14) to the Chain by using another C-clip. Replace
Arm Curl Handle with the Ankle Strap (#51) or Single Handle (#52) for various
exercises. Adjust the length of Chain to obtain the desired exercise. Remove the
Arm Curl Handle, Ankle Strap, or Single Handle when using the Leg Developer.
17