Filter
Top Products
ASSEMBLY INSTRUCTION
Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen
Wrenches. NOTE: It is strongly recommended two or more people assembling this
machine to avoid possible injury.
STEP 1 (See Diagram 1)
A.) Connect the two Upright Beams (#1) by a Cross Brace (#2) in the mid-span. Align the
holes and secure each end of the Cross Brace with two M10 x 3 1/8” Carriage Bolts
(#44), one 4 ¾” x 2” Bracket (#21), two ∅ ¾” Washers (#52), and two M10 Aircraft
Nuts (#51).
B.) Insert two Crutches (#10) into the top openings on the Upright Beams. Secure them
with two Lock Knobs (#38) through selected holes to obtain desired height of the
Supports.
C.) Place the Backrest Adjustment Bar (#8) onto the selected slot on Upright Beams to
hold the desired incline.
D.) Insert one Weight Post (#11) to each Upright Beam. Secure it with one M10 x 1” Allen
Bolt (#46) and ∅ ¾” Washer (#52). Attach one Olympic Sleeve (#36) to each Post.
Secure the Sleeve to the post with one M8 x ½” Allen Screw (#55). Attach a Spring
Clip (#25) to each Sleeve.
DIAGRAM 1
4