Filter
Top Products
ASSEMBLY INSTRUCTION
Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen
Wrenches.
NOTE: It is strongly recommended two or more people assembling this machine to
avoid possible injury.
STEP 1 (See Diagram 1)
A.) NOTE: Do not tighten the Nuts and Bolts until instructed to do so.
B.) Connect the Left & Right Base Frames (#26 & #27) by a Cross Brace (#36) in the mid-
span. Secure each end of the Cross Brace with two M10 x 2 ½” Carriage Bolts (#102),
one 4 3/8” x 1 ¾” Bracket (#56), two Ø ¾” Washers (#89), and two M10 Aircraft Nuts
(#106).
C.) Attach a Front Vertical Beam (#24) to the Left Base Frame (#26). Secure it with two
M10 x 2 ¾” Carriage Bolts (#103), one 4 ¾” x 2” Bracket (#57), two Ø ¾” Washers
(#89), and two M10 Aircraft Nuts (#106). Repeat the same procedure to install the
other side.
D.) Attach the Front Top Beam (#43) to the two Front Vertical Beams. Secure each end
with one M10 x 2 ½” Allen Bolt (#96), 4” x 2” Bracket (#55), and Ø ¾” Washer (#89) to
the top hole. Secure the bottom hole with one M10 x 2 ¾” Carriage Bolt (#103), Ø ¾”
Washer (#89), and M10 Aircraft Nut (#106).
E.) Insert a Guide Rod (#35) into the hole on the Left Base Frame (#26). Secure it with
one M10 x 1” Allen Bolt (#92) and ∅ ¾” Washer (#89) from the bottom.
F.) Slide a Lower Safety Stop Frame (#52) and a Safety Stop Frame (#32) onto the Guide
Rod (#35).
G.) Secure the top of the Guide Rod to the Front Vertical Beam with one M10 x 1” Allen
Bolt (#92) and ∅ ¾” Washer (#89).
H.) Attach a Safety Hook (#53) to the Lower Safety Stop Frame (#52). Secure it with one
M10 x 1” Allen Bolt (#92), two ∅ ¾” Washers (#89), and one M10 Aircraft Nut (#106).
I.) Attach the Safety Hook to the selected hole on the Front Vertical Beam.
J.) Repeat procedures E through I above to install the other side.
8