Filter
Top Products
STEP 3 (See Diagram 3)
A.) Attach the brackets at the end of the Backrest Supports (#32) to the pivot on the Sliding
Block (#6). Align the holes on the Seat Support (#16) to the brackets on the Backrest
Supports. Secure them together with one M12 x 7 5/8” Allen Bolt (#60), two ∅ 1”
Washers (#66) and one M12 Aircraft Nut (#69).
B.) Attach the Backrest Board (#26) to the Backrest Supports. Secure it with four M8 x 1 5/8”
Allen Bolts (#62) and Ø 5/8” Washers (#65). Place the other end of Backrest Board rest
against the Backrest Adjustment Bar.
C.) Place the Seat Pad (#27) onto the Seat Support (#16). Secure it with four M8 x 1 5/8”
Allen Bolts (#62) and Ø 5/8” Washers (#65).
D.) Insert a 4 ¾” Lock Pin (#36) into the selected hole on the Seat Support to obtain the
desired Seat inclined position.
8