Filter
Top Products
STEP 4 (See Diagram 4)
A.) Insert two M10 x 2 3/8” Carriage Bolts (#56) all the way through the holes on the Leg
Developer Holder (#5), then insert the two Bolts through the holes on the Main Seat
Support (#4). Attach the Leg Developer Holder to the Main Seat Support. Secure them with
the two M10 x 2 3/8” Carriage Bolts, one 4 ¾” x 2” Bracket (#45), two Ø ¾” Washers (#64),
and two M10 Aircraft Nuts (#67). Thread a M18 x Ø 5/8” Lock Knob (#47) into the nut on
the Leg Developer Holder.
B.) Attach the Leg Developer (#13) to the Leg Developer Holder. Secure it with one M10 x 3
½” Allen Bolt (#57), two ∅ ¾” Washers (#64), and one M10 Aircraft Nut (#67).
C.) Insert two Foam Tubes (#18) halfway through the holes on the Leg Developer. Push four
Foam Rolls (#37) onto the Tubes from both ends. Plug four Foam Roll End Caps (#43)
into the ends.
D.) Slide an Olympic Sleeve (#44) onto the weight post on the Leg Developer. Attach a Spring
Clip (#48) to the Sleeve.
E.) Attach the Arm Curl Handle (#30) to the back holes on the Leg Developer. Secure it with
one 3” Lock Pin (#35). Attach the Abdominal Strap (#31) to the front holes on the Leg
Developer. Secure it with another 3” Lock Pin.
DIAGRAM 4
9