Filter
Top Products
STEP 4 (See Diagram 4)
A.) Attach the Leg Developer (#8) to the Leg Developer Holder (#5). Secure it with one M10 x
3 1/8” Allen Bolt (#61), two ¾” Washers (#70), and one M10 Aircraft Nut (#68).
B.) Insert the Leg Developer Weight Post (#25) into the hole on Leg Developer. Secure it with
one M10 x 2 3/8” Allen Bolt (#58), two Ø ¾” Washers (#70), and one M10 Aircraft Nut
(#68). Cover the end of Post with one Ø 1” x Ø 3/8” Spacer (#38) and one Ø 1 1/8” x 1 1/8”
Rubber Bumper (#49).
C.) Attach the Arm Curl Handle (#23) to the hole on the Leg Developer. Secure it with the Lock
Pin (#46).
D.) Insert the Long Foam Tube (#29) halfway through the hole on Leg Developer Holder. Insert
two Foam Tubes (#28) halfway through the holes on Leg Developer.
DIAGRAM 4
10