Impex IVT-451 Fitness Equipment User Manual


 
ASSEMBLY INSTRUCTION
Tools Required for Assembling the Machine: Two Adjustable Wrenches and Allen
Wrenches.
NOTE: It is strongly recommended that two or more people assemble this machine
to avoid possible injury.
STEP 1 (See Diagram 1)
A.) Do not fasten the Nuts and Bolts until instructed to do so.
B.) Attach Front Support Frame (#1) to Rear Support Frame (#2). Secure them together
with one M10 x 1” Allen Bolt (#34), two Ø ¾” Washers (#45), and one M10 aircraft Nut
(#43) on each end.
C.) Attach a Ø ¾” Rubber Spacer (#24) to the lower hole on Rear Support Frame. Attach
one Short Horizontal Support (#3) to the Spacer. Align the holes. Secure the Short
Horizontal Support, Spacer, and Rear Support Frame together with one M8 x 2 5/8”
Allen Bolt (#37), one Ø 5/8” Washer (#46), and one M8 Aircraft Nut (#43). Repeat the
same procedure to install the Right Long Horizontal Support (#4) to Front Support
Frame.
D.) Connect the Short and Long Horizontal Support together with one M6 x ½” Allen Bolt
(#33), one Ø ½” Washer (#47), and one M6 Aircraft Nut (#44).
E.) Repeat Procedure C & D to install the other side.
F.) Press down the Short and Long Horizontal Support completely to stabilize the Front
and Rear Support Frame.
G.) Securely fasten all Nuts and Bolts installed.
5