Filter
Top Products
STEP 2 (See Diagram 2)
A.) Do not tighten Nuts and Bolts until instructed to do so.
B.) Attach the rear of the Main Seat Support (#9) to the Rear Stabilizer (#11). Secure it with
two M10 x 2 ¾” Carriage Bolts (#46) from bottom, one 4 3/8” x 1 ¾” Bracket (#28), two
Ø ¾” Washers (#54), and two M10 Aircraft Nuts (#56).
C.) Place the Main Seat Support onto the Front Post (#10). Attach the Seat Bracket ($12)
onto the Main Seat Support. Secure them together with M10 x 2 ¾” Carriage Bolts
(#46), two Ø ¾” Washers (#54), and two M10 Aircraft Nuts (#56).
D.) Secure the leg developer holder on Main Seat Support to the Front Post with one M10 x
2 ¾” Allen Bolt (#49) and one Ø ¾” Washer (#54).
E.) Securely tighten all Nuts and Bolts installed.
DIAGRAM 2
6