Filter
Top Products
ASSEMBLY INSTRUCTION
Tools Required Assembling the Machine: Adjustable Wrench and Allen
Wrench
NOTE: It is strongly recommended this machine to be assembled by two or
more people to avoid possible injury.
STEP 1 (See Diagram 1)
A.) Attach a Rear Stabilizer (#11) to the bottom of the Upright Beam (#9). Secure it
with one Bracket (#15), four M10 x 2 ¾” Carriage Bolts (#12), ∅ ¾” Washers
(#13) and M10 Aircraft Nuts (#14). Repeat the same step for the other side.
B.) Place the Backrest Adjustment Bar (#7) on the selected bar holder on the Upright
Beam (#9) to obtain desired incline of Backrest.
C.) Insert two Crutches (#4) into the top openings on the Upright Beams (#9). Secure
them with two Lock Knobs (#6) through selected holes to obtain desired height of
the Crutches. Make sure both sides are at the same height.
DIAGRAM 1
4