Filter
Top Products
STEP 2 (See Diagram 2)
A.) Slide a ∅ 1 ½” Plastic Spacer (#49) onto the Axle on the Adjustment Plate (#4). Insert
the Axle through the Pivot Barrel on the Main Frame. Slide another Spacer onto the
Axle.
B.) Slide the Weight Holder (#7) onto the Axle and align the holes. Insert a Roll Pin (#12)
through the hole and drive it in with a hammer.
C.) Attach the Leg Developer Frame (#19) onto the Axle on the Adjustment Plate (#4).
Secure it with one M10 x ¾” Allen Bolt (#28) and ∅1 3/8” Washer (#27).
D.) Slide the Knee-lock Frame (#13) onto the pivot axle on the Main Frame. Secure it with
one M10 x ¾” Allen Bolt (#28) and ∅1 3/8” Washer (#27).
E.) Attach the open bracket on the Handle (#6) to the Seat Support (#2). Secure it with two
M10 x 2 ¾” Carriage Bolts (#46), ∅ ¾” Washers (31), and M10 Aircraft Nuts (#35).
DIAGRAM 2
5