Filter
Top Products
ASSEMBLY
To hire an authorized service technician to assemble the treadmill, call toll-free 1-800-445-2480.
Assembly requires two persons.
Set the treadmill in a cleared area and remove all packing materials; do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is
coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the
top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor-
mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild,
non-abrasive cleaner.
Assembly requires the included allen wrenches and your own phillips screwdriver ,
rubber mallet , adjustable wrench , and needlenose pliers .
For help identifying the assembly hardware, see the drawings below.
If a part is not in the parts bag, check
to see if it has been pre-assembled. To avoid damaging plastic parts, do not use power tools for assembly.
1. Make sure that the power cord is unplugged.
With the help of a second person, carefully tip the tread-
mill onto its left side as shown. Partially fold the Frame
(86) so the treadmill is more stable. Do not fully fold the
treadmill until it is completely assembled.
See the inset drawing. Make sure that there are two U-
Nuts (99) in the lower end of each Upright (7, 90). Identify
the Right Upright (90) with the sticker. Hold the Right
Upright near the right side of the Upright Base (69), with
the Right Upright turned as shown. Feed the colored tie
and Upright Wire (42) into the lower end of the Right
Upright and out of the upper end.
Pull on the end of the Upright Wire to remove any slack as
you hold the Right Upright (90) against the Upright Base
(69);
be careful not to pinch the Upright Wire (42). Start
a 3” Upright Bolt (21) and a 1“ Upright Bolt (76) with 5/16”
Star Washers (95) into the Upright Base and the Right
Upright as shown.
Do not tighten the Bolts yet.
3/4” Screw (2)–7
Nut (13)–2
Wheel Bolt (64)–2
Silver Ground
Screw (75)–1
1” Tek Screw (39)–8
5/16” Star Washer
(95)–8
1/2” Screw (48)–2
Handrail Bolt (37)–4
3” Upright Bolt (21)–2
1” Upright
Bolt (76)–2
69
86
42
42
90
Tie
76
1
21
99
7, 90
6
95