Filter
Top Products
7
3. Attach the Bench Leg (1) to the Bench Frame (5)
with two Bench Joint Plates (18), four M10 x 70mm
Bolts (21), and four M10 Nylon Locknuts (11).
Note: Tighten all the M10 Nylon Locknuts (11)
used in steps 1-3.
3
1
11
18
5
21
18
4. Press two 25mm x 40mm Inner Caps (28) into each
Backrest Tube (27). Press two 25mm x 40mm Inner
Caps into the Backrest Adjustment Bracket (35).
Lubricate an M10 x 190mm Bolt (22). Attach the
Backrest Tubes (27) to the welded tube on the
Backrest Adjustment Bracket (35) with the Bolt, two
M10 Washers (6), and an M10 Nylon Locknut (11).
Make sure that the Backrest Tubes are turned as
shown. The indicated holes are not centered in
the Backrest Tubes but are closer to one side.
Turn the Backrest Tubes so the holes are closer
to the floor. Do not over tighten the Nylon
Locknut; the Backrest Tubes must pivot easily.
4
28
11
35
Lubricate
Holes
Welded
Tube
28
28
22
6
6
27
5. Lubricate an M10 x 190mm Bolt (22). Attach the
Backrest Tubes (27) to the welded tube on the
Bench Frame (5) with the Bolt, two M10 Washers
(6), and an M10 Nylon Locknut (11). Note: Do not
over tighten the Nylon Locknut; the Backrest
Tubes must pivot easily.
5
27
11
5
22
6
6
Lubricate
Welded Tube
6. Attach the Backrest (15) to the Backrest Tubes (27)
with four M6 x 55mm Screws (4) and four M6
Washers (30).
6
30
4
15
27