Filter
Top Products
9
4. Remove the power cord from the Spa Jet Unit (13).
With the help of a second person, place the Spa Jet
Unit (13) over the Side Panel (1) and the section of
the Inflatable Spa Liner (9) which does not have the
cushion. Be extremely careful not to tear the
Inflatable Spa Liner (9) as you slide the Spa Jet
Unit into place.
5. Before you fill the RENEW 900, be sure that it is in
the position you want, and that it can be easily ser-
viced, if needed. Once the RENEW 900 is filled with
water, it will need to be drained to be moved.
Using a garden hose or other clean water source,
begin filling the RENEW 900, until the jet and filter
openings on the Spa Jet Unit (13) are covered with
water. Do not fill the RENEW 900 more than 20”
deep with water.
After the RENEW 900 is full, you must prime the
Spa Jet Unit (13) before using the RENEW 900
(see PRIMING THE SPA JET UNIT on page 10).
6. Attach the nozzle on the included air pump to the
valve on the Inflatable Cover (4). Use the Air Pump
to fill the Inflatable Cover (4) with air. Remove the
nozzle from the Inflatable Cover.
Slide one of the straps on the inside of the Spa
Cover (11) through one of the loops on the
Inflatable Cover (4). Attach the latch on the strap to
the buckle on the other end.
Attach the other three straps on the inside of the
Spa Cover (11) through the loops on the Inflatable
Cover (4) in the same manner.
7. Place the Spa Cover (11) over the Side Panels (1,
2) and the Spa Jet Unit (13). Be sure that the Spa
Cover is properly centered and that the straps
on the Spa Cover line up with the straps extend-
ing from the slots in the Side Panels (1, 2).
Snap each of the six latches on the Spa Cover (11)
into the buckles on the straps extending from the
slots in the Side Panels (1, 2).
7
4
5
6
4
11
1
9
13
13
9
Power
Cord
1, 2
11
13
Latches and Buckles
Latch and
Buckle