Filter
Top Products
3
IMPORTANT SAFETY INSTRUCTIONS
WARNING: To reduce the risk of drowning, electric shock, or serious injury, read the following
important precautions before using the RENEW 900.
READ AND FOLLOW ALL INSTRUCTIONS
1. It is the responsibility of the owner to ensure
that all users of the RENEW 900 are ade-
quately informed of all precautions.
2. Use the RENEW 900 only as described in this
manual.
3. The RENEW 900 is intended for home use
only. Do not use the RENEW 900 in any com-
mercial, rental, or institutional setting.
4. Use the RENEW 900 only on a level surface.
Do not use the RENEW 900 on carpet or
other materials that could be damaged by
moisture. Do not use the RENEW 900 on
rough or sharp surfaces such as gravel or
wood chips.
5. The RENEW 900 will weigh approximately
2400 pounds when it is assembled and filled
with water. Be sure that the location you
select for the RENEW 900 will support this
weight, plus the weight of the occupants.
6. Inspect and tighten all parts regularly.
Replace any worn parts immediately.
7. DANGER—Risk of injury: Do not remove or
alter the covers on the suction fittings. Never
operate the RENEW 900 if the suction guard
is missing or broken. Keep hair and body
away from the suction guard. If you need to
replace a suction fitting, be sure that the flow
rate of the replacement is compatible.
8. Do not bring any object into the RENEW 900
that could puncture the liner.
9. Never insert any object into any opening.
10. Do not sit on the spa cover or place objects
on it. It is not designed to support weight.
11. Remove any water which may collect on the
spa cover.
12. Keep children and pets away from the
RENEW 900 when it is not in use.
13. Keep all chemicals away from children and
pets.
14. The pH and chemical balance of the water
must be maintained as explained in this man-
ual (see page 13). Failure to do so may cause
injury to users or damage to the spa jet unit,
and will void the warranty.
15. The water pump in the spa jet unit must be
primed before you use the RENEW 900 the
first time. You must also prime the pump
before using the unit each time you re-fill the
spa. The spa jet unit may be seriously dam-
aged if the pump is not properly primed (see
PRIMING THE SPA JET UNIT on page 10).
16. DANGER—When connecting the power cord
(see PLUGGING IN THE RENEW 900 on page
10), plug the power cord directly into a
grounded circuit capable of carrying 15 or
more amps. No other appliance should be on
the same circuit. Replace the power cord
immediately if damaged.
17. Do not use an extension cord with the
RENEW 900. This could damage the motor
and will void the warranty.
18. DANGER—If you will be using the RENEW
900 outside, do not bury the power cord; you
should also keep the power cord away from
lawn mowers, hedge trimmers, and other
similar equipment.
19. WARNING—The power cord is equipped with
a Ground Fault Circuit Interrupter (GFCI),
located at the end of the power cord. The
GFCI must be tested before each use. To test
the GFCI, press the “test” button while the
spa jet unit is running. The spa jet unit
should shut off. Press the “reset” button.
The spa jet unit should resume normal oper-
ation. If the spa jet unit continues to run after
the “test” button is pressed, then the GFCI is
damaged. Do not use the RENEW 900 until
the GFCI has been repaired or replaced by a
qualified electrician.