Filter
Top Products
20
P/N 205331C 10/01
Stack and Bounce top and middle pole sections
together.
Bounce pole sections together until top section no
longer moves toward taped reference mark.
Fit upper pole sections to bottom section.
After pole sections are positioned use sledge
hammer and a wood scrap to pound pole sections
together.
IMPORTANT! Pound pole sections together until
poles no longer move toward taped reference mark
on bottom pole, overlapping 4”-5” (10.2-12.7cm).
Fill pole with concrete approximately 1” (2.54cm)
below bottom hole (as shown above).
IMPORTANT!
POLES MUST OVERLAP 4” TO 5” (10.2-12.7CM)
IMPORTANT!
FAILURE TO FILL YOUR POLE COMPLETELY WITH
CONCRETE AS DESCRIBED IN THESE INSTRUCTIONS
WILL VOID ALL WARRANTIES WRITTEN AND IMPLIED.
DO NOT PROCEED
TO STEP 8
UNTIL CONCRETE
HAS CURED!
WARNING!
PLAYING SURFACE
8.
9.
10.
11.
7.
6.
WOOD SCRAP
• Chute de Planche
• Madera Sobrante
• Tavolozza di Legno
• Madeira de Refugo
• Holzbrett (Abfallstück)
• Stukje Hout
• Trækrot
• Trebit
• Använt Trästycke
WOOD SCRAP
• Chute de Planche
• Madera Sobrante
• Tavolozza di Legno
• Madeira de Refugo
• Holzbrett (Abfallstück)
• Stukje Hout
• Trækrot
• Trebit
• Använt Trästycke
PLAYING SURFACE
• Surface de jeu
• Superficie de juego
• Superficie di giuoco
• Área de Jogo
• Spielfläche
• Speeloppervlak
• Spilleflade
• Spillebane
• Spelplan