Filter
Top Products
12/06 ID# M6809011
9
Correctly identify each pole section. Poles have an identification sticker that will be used as a
reference point in the next step.
2.
4
6
BOTTOM
TOP
5
MIDDLE
IDENTIFICATION STICKER
IDENTIFICATION STICKER
Bounce middle pole section (5) into top section (4) using a wood scrap as shown until the top pole no
longer moves toward the pole identification sticker on the middle pole.
3.
5
4
Wood Scrap (not supplied)
THE IDENTIFICATION STICKER IS
LOCATED 5" FROM THE END OF
THE POLE. WHEN PROPERLY
POUNDED TOGETHER, THE POLE
SECTIONS SHOULD HAVE A 4-1/2"
MINIMUM OVERLAP, LEAVING 1/2"
BETWEEN THE OVERLAPPING POLE
AND THE IDENTIFICATION STICKER.
CAUTION!
IMPORTANT!
NOTE ORIENTATION OF
POLES.