Filter
Top Products
8
ID# M611701 12/05
2.
IMPORTANT!
ONCE POLE SECTIONS ARE POUNDED TOGETHER- THEY CANNOT BE TAKEN APART
THE IDENTIFICATION STICKER IS
LOCATED 5" FROM THE END OF
THE POLE. WHEN PROPERLY
P
OUNDED TOGETHER, THE POLE
S
ECTIONS SHOULD HAVE A 3-1/2"
MINIMUM OVERLAP, LEAVING 1-1/2"
B
ETWEEN THE OVERLAPPING
POLE AND THE IDENTIFICATION
STICKER.
CAUTION!
5
4
4
5
6
Align poles using alignment marks. First, pound top
and middle poles together by bouncing them on a scrap
piece of wood on the ground as shown in FIG A. until
they no longer move toward pole identification stickers.
THEN add bottom pole section and pound together in
the same way FIG B.
FIG. A.
FIG. B.
TROUGH
TROUGH
GORGE
RINNE
CANAL
TROUGH
GORGE
RINNE
CANAL
IMPORTANT!
HOLE
DIMPLE
TROUGH
TROUGH
TROUGH
ID STICKER
ID STICKER
5"
ID
S
TICKER
1-1/2"
TROUGH
Wood Scrap
(NOT SUPPLIED)
DIMPLE