Filter
Top Products
10
P/N 21447703 03/04
3.
Align dimple of middle pole with slot of bottom pole. While maintaining alignment, bounce top and
middle pole assembly (1 & 2) onto lower pole section (3) as shown until the top and middle pole
assembly (1 & 2) no longer moves toward the pole identification mark on bottom pole (3).
1
2
3
WOOD SCRAP
(NOT SUPPLIED)
IDENTIFICATION
STICKER
RODS SHOWN ARE
FOR VISUAL
REPRESENTATION
OF ALIGNMENT
AND ARE NOT
SUPPLIED WITH
THE HARDWARE
IMPORTANT!:
Holes in top (1) and
bottom pole (3) sections
MUST align to correctly
position elevator system
toward playing surface.
POLE SECTIONS
SHOULD HAVE A
3-1/2" (9 CM) MINIMUM
OVERLAP.
NOTE:
1-1/2"
Bottom Pole
Bottom Pole
IDENTIFICATION
STICKER
5"