Filter
Top Products
12
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
TREADMILL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
Y O U ’ R E F I N I S H E D !
POWER SWITCH
CIRCUIT BREAKER
A Open HARDWARE BAG 4.
B Slide SUPPORT BARS onto side
MOUNTING BRACKETS and
line up with top MOUNTING
BRACKETS.
C Insert 2 BOLTS (E) into the
tops and 2 BOLTS (E) into the
bottoms of each SUPPORT BAR.
The BRACKET should be on the
outside of the SUPPORT BAR
as shown in the drawing to the
left.
D Slide SUPPORT BAR BOOTS
down to cover BOLTS (E).
A S S E M B LY S T E P 4
MOUNTING BRACKET
BOLT (E)
(8 TOTAL)
SUPPORT BAR BOOT
SUPPORT BARS
BRACKET
SUPPORT BAR
STEP C
#0-5&
NN
2UZ
UPQWJFX
HARDWARE BAG 4 CONTENTS :
Connect power plug to the treadmill
and connect the cord to a power
outlet. The on/off switch is located
next to the power cord. Flip this
switch to the 'ON' position, so that
the switch is lit. You will hear a beep
and the console will light up.
A S S E M B LY S T E P 5