Filter
Top Products
BEFORE
YOU BEGIN
10
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
TREADMILL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
11
INTRODUCTION
IMPORTANT
PRECAUTIONS
TREADMILL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
A Open HARDWARE BAG 3.
B Slide CONSOLE MAST BOOTS
down over CONSOLE MASTS and
MAIN FRAME.
C Insert 2 SCREWS (F) into holes
of each CONSOLE MAST BOOT.
D Remove CONSOLE from box and
place out of the way.
ASS EMB LY STEP 3
SCREWS (F)
CONSOLE MAST BOOT
CONSOLE MAST
MAIN FRAME
SCREW (F)
20 mm
Qty: 4
HARDWARE BAG 3 CONTENTS :
A Open HARDWARE BAG 4.
B Connect CONSOLE CABLES. Carefully tuck CONSOLE CABLES into the CONSOLE MAST
before attaching the CONSOLE to avoid damage.
*NOTE: Do not pinch console cables. Be sure the console cable prongs are aligned and
the ends are tightly seated into each other. Look through the holes on the right side of the
console before inserting bolts in step D.
C Attach CONSOLE to LEFT CONSOLE MAST by placing 2 BOLTS (G) with 2 FLAT WASHERS (B)
into side of CONSOLE and lightly tighten.
D Repeat step C above to secure the CONSOLE to the RIGHT CONSOLE MAST.
E Tighten all bolts completely.*
F Insert RUBBER PLUG into iPod
®
DOCKING STATION.
ASS EMB LY STEP 4
DO NOT ATTACH THIS
SIDE UNTIL STEP 4-D
FLAT WASHERS (B)
CONSOLE
BOLTS (G)
FLAT WASHERS (B)
BOLTS (G)
CONSOLE
CABLES
CONSOLE MAST
FLAT WASHER (B)
8 mm
Qty: 4
BOLT (G)
20 mm
Qty: 4
HARDWARE BAG 4 CONTENTS :
Rubber Plug
iPod
®
Docking
Station
T1200_Treadmill_Rev.1.9.indd 10-11 6/22/07 4:45:18 PM