Filter
Top Products
BEFORE
YOU BEGIN
12
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
13
INTRODUCTION
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
IMPORTANT
PRECAUTIONS
A S S E M B LY S T E P 7
NOTE: There is NO hardware bag for this step.
All hardware is pre-installed.
A) Attach the CONSOLE MAST wires to the
CONSOLE wires .
B) Carefully tuck the CONSOLE MAST wires
into the CONSOLE MAST before attaching
the CONSOLE.
C) Attach CONSOLE to the CONSOLE MAST
using the 4 PRE-ATTACHED SCREWS
(screws will have to be removed from the
console first).
DO NOT PINCH WIRES!
Y O U ’ R E F I N I S H E D !
NUT (E)
INSIDE DIAMETER:
8 mm
Qty: 2
BOLT (F)
60 mm
Qty: 2
SPACER (G)
44 mm
Qty: 2
TEFLON WASHER (H)
24 mm
Qty: 4
SCREW (L)
Qty: 2
HARDWARE BAG FOR STEP 5 CONTENTS :
CONSOLE
CONSOLE MAST
CONSOLE WIRES
PRE-ATTACHED
SCREWS
AC ADAPTOR INPUT
A S S E M B LY S T E P 5 (CONTINUED)
Connect AC ADAPTOR to the AC ADAPTOR INPUT, located at front of the main frame. Connect
ADAPTOR to a power outlet. Locate the ON / OFF switch on the back of the CONSOLE. Flip the switch
to the ON position. After a “beep”, the CONSOLE will light up.
A S S E M B LY S T E P 6
WATER BOTTLE HOLDER
PRE-ATTACHED SCREWS
CONSOLE MAST
NOTE: There is NO hardware bag for this step. All hardware is pre-installed.
A) Attach WATER BOTTLE CAGE to CONSOLE MAST using PRE ATTACHED SCREWS.
LS_635E_User_Guide_Rev.1.2.indd 12-13 3/29/07 1:07:35 PM