Filter
Top Products
12
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
TREADMILL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
13
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
TREADMILL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
SET SCREW (I)
12 mm
Qty: 4
BOLT (J)
100 mm
Qty: 2
SPRING WASHER (K)
15.4 mm
Qty: 2
ARC WASHER (L)
18 mm
Qty: 2
A S S E M B LY S T E P 4
SET SCREWS (I)
HANDLEBARS
CONSOLE
SET SCREW (I)
12 mm
Qty: 4
BOLT (J)
100 mm
Qty: 2
SPRING WASHER (K)
15.4 mm
Qty: 2
ARC WASHER (L)
18 mm
Qty: 2
HARDWARE BAG 4 CONTENTS :
A Open HARDWARE BAG 4.
B Attach LEFT HANDLEBAR to CONSOLE using 2 SCREWS (I) .
C Repeat on other side.
A S S E M B LY S T E P 4 ( C O N T I N U E D )
Y O U ’ R E F I N I S H E D !
POWER SWITCH
CIRCUIT BREAKER
Connect power plug to the treadmill
and connect the cord to a power
outlet. The on/off switch is located
next to the power cord. Flip this
switch to the 'ON' position, so that
the switch is lit. You will hear a beep
and the console will light up.
CONSOLE MAST
BOLT (J)
SPRING WASHER (K)
ARC WASHER (L)
HANDLEBAR
HARDWARE BAG 4 CONTENTS :
Continue using HARDWARE BAG 4.
Fasten LEFT HANDLEBAR to CONSOLE MAST using 1 BOLT (J), 1 SPRING WASHER (K) and 1
ARC WASHER (L).
NOTE: Look into holes in the right mast before inserting bolts to avoid pinching cables.
Repeat on other side.
A
B
C
LS780T_Rev.1.3.indd 12-13 6/2/08 4:40:35 PM