Filter
Top Products
9
1
STEP 1:
ATTACH MOBILE WHEEL/SLEEVE.
Note: Make sure not to tighten
bolts until all assembly steps have
been completely assembled and
aligned.
STEP 2:
ATTACH REAR FOOT SUPPORT
TUBE.
STEP 3:
ATTACH SEAT AND SEAT POST.
Note: Slide seat post into position
and lock with the pop pin.
Note: Bolts, nuts and washers are
pre-attached to seat.
J
2
3
4 5
6
7
STEP 4:
ATTACH LEFT & RIGHT PEDALS.
Note: Both pedals are labeled L
for left and R for right. To tighten
turn the left pedal COUNTER
CLOCKWISE and the right pedal
CLOCKWISE.
STEP 5:
ATTACH HANDLEBAR.
STEP 6:
ATTACH CONSOLE MAST.
Note: Make sure to loosen the
water bottle screws in order to fit
the console cable through the
mast. DO NOT PINCH WIRES!
STEP 7:
ATTACH TENSION KNOB. (B51 model only)
Note: Bolt is pre-attached to tension knob.
The resistance indicator is located on the front of the
tension knob.
STEP 8:
ATTACH CONSOLE AND CONNECT ALL WIRES.
Note: DO NOT PINCH WIRES!
Bolts are pre-attached.
L
R
G
F
H
A
E
8
B51
B52HR
B
D
E
C
E