Filter
Top Products
WEIGHT STACK ASSEMBLY
Step 2d
1 - Weight frame Upright
2 - Top Pulley Mount
3 - Weight Stack Mount
6 - Front Upright
13 - Guide Rod Top Mount
14 - Latch Assembly
15 - Guide Rod
22 - 20 lb. Intermediate Weight
23 - 12 1/2 lb. Intermediate Weight
24 - 8 1/4 lb. Top Plate
Part Descriptions
C - 1/2”-13UNC x 3 1/4” Hex Head Bolt (WZ)
G - 3/8”-16UNC x 3/4” Square Head Set Screw
U - 5/16”-18UNC x 5/16”-Scocket Set Screw
AA - 1/2” Washer
BA - 1/2” Nylok Nut
CH - Weight Stack Bumper
CK - Latch Spring
CL - Latch Pin
CM - C-Clip
Hardware Descriptions
Page - 11
HD1700 Assembly
OWNERS
MANUAL
Continue assembly by attaching (14) and (CK) to (6). Now slide (15)
through (CH) and slide them both into (3). Tilt both (15)’s forward
enough to allow room to slide the Weight Plates on. Slide all 10 (22)’s and
all 5 (23)’s onto both (15)’s. Now slide (24) onto both (15)’s. Slide (13)
over both (15)’s. Angle both (15)’s vertical and secure (13) to both (1) and
(2). Secure both (15)’s to (13) using set screw (U). bolts.Wrench Tighten