Filter
Top Products
24
H
OW TO USE THE INFORMATION MODE
The console features an information mode that allows
you to view treadmill usage information, select a sys-
t
em of measurement for the console, and turn on and
t
urn off the demo mode. The information mode also al-
lows you to adjust the settings of the television and to
save channels into the television’s memory.
Follow the steps below to use the information mode.
Hold down the Stop button while inserting the
key into the console.
When the information mode is selected, the upper
part of the display will show the total number of
miles or kilometers that the walking belt has
moved. The right side of the display will show the
total number of hours that the treadmill has been
used.
In addition, the display will show the letter “E” for
English miles or the letter “M” for metric kilometers.
Press the Speed increase button to change the
unit of measurement if desired.
IMPORTANT: If the letter “d” appears in the center
of the display, the “demo” mode is selected. This
mode is intended to be used only when a treadmill
is displayed in a store. When the demo mode is
selected, the power cord can be plugged in, the
key can be removed from the console, and the dis
-
plays on the console will automatically light in a
preset sequence. The buttons on the console will
not function. If a “d” appears in the display
when the information mode is selected, press
the Speed decrease button.
Press the On/Off button and adjust the
brightness, contrast, color, sharpness, and/or
hue of the television.
When the On/Off button is pressed, the brightness
level indicator will appear on the television screen.
Press the Volume buttons to adjust the brightness
setting if desired.
Next, press the Channel buttons until the contrast,
color, sharpness, or hue level indicator appears.
Adjust the settings, if desired, by pressing the
Volume buttons.
Press the On/Off button again and add or
delete channels.
After all valid channels available in your area have
been saved into the television’s memory (see step
5 on this page), you can manually add channels
or delete unwanted channels.
To add or delete a channel, first press the
Channel buttons until the desired channel number
appears on the screen. Then, press the Volume
increase button to add the channel, or the Volume
decrease button to delete the channel. Continue
this process until you have added all desired
channels and deleted all unwanted channels.
Press the On/Off button again and select an
antenna connection or a cable connection.
After the On/Off button is pressed, press the
Volume decrease button to select the Air setting,
the Volume increase button to select the Standard
Cable setting, the Channel decrease button to se-
lect the Cable IRC setting, or the Channel in-
crease button to select the Cable HRC setting.
Note: The setting that you select will not appear
on the screen. If you have connected an antenna
to the treadmill, the Air setting should be selected.
If you have connected a CATV cable, one of the
three Cable settings should be selected; try all
three Cable settings, if necessary, to find the opti-
mal setting.
Press the On/Off button again and save
channels into the television’s memory.
When the On/Off button is pressed, the television
will begin scanning all of the channels available in
your area. When no broadcast signal is detected
on a channel, the channel will be skipped. When a
broadcast signal is detected, the channel will be
saved into memory and the next channel will be
selected. This process will continue until the high-
est channel is reached.
Do not remove the key
while the television is scanning channels.
When you are finished using the information
mode, remove the key.
To exit the information mode at any time (except
while the television is scanning channels), remove
the key from the console.
6
5
4
3
2
1