Filter
Top Products
8
5. With the help of a second person, carefully raise
the Left Upright (70) and the Right Upright (not
s
hown) to a vertical position.
R
emove the knob from the pin. Make sure that
the collar and the spring are on the pin. (Note: If
there are two collars, place one on each side of
the spring.) Then, insert the pin into the Latch
Housing (71), and tighten the knob onto the pin.
See steps 2 and 4. Fully tighten the two
Endcap Screws (79).
7
0
Pin
Collar
Spring
Knob
5
7
1
6. Slide a Handrail (62) onto the post on the Left
Upright (70). Finger tighten two 1 1/4" Bolts (63)
into the Handrail and the post; do not fully
tighten the Bolts yet.
Attach the other Handrail (62) to the Right
Upright (76) in the same way.
70
Post
62
62
63
63
76
6
7. Make sure that the Upright Wire (75) is posi-
tioned at the side of the post on the Right
Upright (76) as shown.
Set the Pulse Bar (66) on the Left and Right
Uprights (70, 76). Attach the Pulse Bar with four
Silver Pulse Bar Screws (64) and four Pulse Bar
Star Washers (65). Start all four Silver Pulse
Bar Screws before firmly tightening them.
Firmly tighten the four 1 1/4" Bolts (63).
70
64
65
64
65
63
76
66
63
7
75