Healthrider HRTL17980 Treadmill User Manual


 
6
ASSEMBLY
Assembly requires two people. Place the treadmill in a cleared area and remove all packing materials. Do not
d
ispose of the packing materials until the treadmill is assembled.
N
o tools are required.
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt, the sides of the walking platform, or
the shipping carton. This does not affect treadmill performance. If there is lubricant on top of the walking belt or
on the sides of the walking platform, wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
1. With the help of a second person, carefully raise the
Uprights (83) until the Wheels (107) are resting on the
floor as shown.
The stainless steel walking platform on your treadmill is
covered with a thin layer of plastic to protect it during
shipping. Before using the treadmill, peel the plastic off
the walking platform.
1
107
4. Make sure that all parts are tightened before you use the treadmill. Place a mat beneath the treadmill
to protect the floor or carpet. For your benefit, we recommend that you familiarize yourself with the
TROUBLE-SHOOTING AND MAINTENANCE section on page 18.
83
2. Next, make sure that the Lock Knob Sleeve (77) is fully
inserted into the left Upright (83).
Remove the Lock Knob (76) from the Lock Pin (81). Make
sure that the Lock Pin Collar (79) and the Spring (78) are
on the Lock Pin. Insert the Lock Pin into the left Upright
(83) and tighten the Lock Knob onto it.
79
81
77
78
76
83
2
Remove
plastic
3. Remove the paper backing from the Wrench Clip (102).
Press the Wrench Clip onto one of the Uprights (83) in
the indicated location. Press the Allen Wrench (101) into
the Wrench Clip. Note: The use of the Allen Wrench is
described on pages 18 and 19.
101
83
102
3