Filter
Top Products
4
ASSEMBLY
Assembly requires two people. Place all parts of the elliptical crosstrainer in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
The following tools are required for assembly: the included allen wrenches and your own
phillips screwdriver adjustable wrench and rubber mallet .
As you assemble the elliptical crosstrainer, use the drawings below to identify the small parts used in assembly.
The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on
page 18. The second number refers to the quantity used in assembly. Note: Some small parts may have been
pre-assembled for shipping. If a part is not in the parts bag, check to see if it has been pre-assembled.
Carriage Bolt (2)Ð2
Handlebar Bolt (92)Ð4
Console Plate
Screw (39)Ð4
M8 x 19mm Button
Screw (76)Ð4
Patch Bolt (90)Ð1
M4 x 16mm
Flange Screw
(88)Ñ6
M4 x 16mm
Screw (60)Ð5
M10 Flat
Washer (94)Ð5
Curved
Washer (74)Ð4
M8 Split
Washer (85)Ð4
M10 Split
Washer (73)Ð4
M10 Nylon
Locknut (55)Ð6
M8 Washer
(89)Ð4