Filter
Top Products
5
1. Before beginning assembly, make sure that you
have read and understand the information on
p
age 4.
Attach one of the Stabilizers (31) to the Main Frame
(1) with two M6 x 62mm Bolts (53), two M6 Flat
Washers (55), and two M6 Nylon Locknuts (54).
Do
not tighten the Nylon Locknuts yet.
1
31
54
55
53
1
1
45
57
57
45
45
34
54
55
1
31
53
2. Attach the other Stabilizer (31) to the Main Frame
(1) with two M6 x 62mm Bolts (53), two M6 Flat
Washers (55), and two M6 Nylon Locknuts (54).
Tighten the four Nylon Locknuts used in steps 1
and 2.
3. Hold the Front Cover Panel (34) against the Main
Frame (1) in the indicted location. Press four
Fastener Bases (45) and four Fastener Pins (57)
into the Front Cover Panel and the Main Frame.
4. Lubricate a Frame Axle (13). Attach the Handlebar
Swing Arm (5) to the Main Frame (1) with the
Frame Axle, two Rubber Washers (51), and two
Axle Fasteners (56).
Note: If the ends of the Frame
Axles (13) are
internally threaded, the Axle Fasteners (56) will
be bolts; if the ends are externally threaded, the
Axle Fasteners will be acorn nuts (see the part
identification chart on page 4).
4
3
1
51
56
51
56
5
Lubricate
—
13
2