Filter
Top Products
5
1. Before beginning assembly, make sure that you
have read and understand the information on
page 4.
Attach one of the Stabilizers (31) to the Main Frame
(1) with two M6 x 60mm Bolts (53), two M6 Flat
Washers (55), and two M6 Hex Nuts (54).
1
31
54
55
53
1
1
45
58
58
45
45
34
54
55
1
31
53
2. Attach the other Stabilizer (31) to the Main Frame
(1) with two M6 x 60mm Bolts (53), two M6 Flat
Washers (55), and two M6 Hex Nuts (54).
3. Attach the Front Cover Panel (34) to the Main
Frame (1) using four Fastener Bases (45) and four
Fastener Pins (58). First, insert the Fastener Bases
through the Front Cover Panel and into the Main
Frame. Next, push a Fastener Pin (58) into the hole
in each Fastener Base until it is flush with the Base.
4. Lubricate a Frame Axle (13). Attach the Handlebar
Swing Arm (5) to the Main Frame (1) with the
Frame Axle, two Rubber Washers (51), and two
Axle Fasteners (56).
Note: If the ends of the Frame Axles (13) are
internally threaded, the Axle Fasteners (56) will
be bolts; if the ends are externally threaded, the
Axle Fasteners will be acorn nuts (see the part
identification chart on page 4).
4
3
1
51
56
51
56
5
Lubricate—13
2