Filter
Top Products
5
8
8
2
3
46
46
50
Holes
5. Slide one of the Handle Sleeves (50) onto the Left
Leg (2). Position the Handle Sleeve slot so that
one set of holes in the Left Leg is visible. Slide
one of the Handles (8) over the Handle Sleeve
and onto the Left Leg. Attach the Handle with four
#8 x 1/2Ó Screws (46).
Attach the other Handle (8) and Handle Sleeve
(50) to the Right Leg (3) in the same manner.
6. The decal shown at the right is found in the indi-
cated location on the AEROFLYER. If the decal
is missing, or if it is not legible, call our
Customer Service Department, toll-free, to
order a free replacement decal (see ORDER-
ING REPLACEMENT PARTS on the back of this
manual). Apply the decal in the location shown.
Fig. 5
Make sure that all parts are properly tightened before
you use the AEROFLYER.
4. Connect the Reed Switch Wire (12) to the wire on
the Electronic Monitor (9). Feed any excess wire
into the Crossbar Cover (19). Press the Monitor
onto the Crossbar Cover so the Fasteners (48) on
the Monitor snap into the holes in the Crossbar
Cover.
Fig. 4
9
48
19
48
12
Do not allow children on or
around machine.
Keep hands and feet away
from moving parts and contact
points.
Read owner's manual and
follow instructions.
!
Fig. 6