Filter
Top Products
7
5. The Console (9) requires two ÒAAÓ batteries (not
included); alkaline batteries are recommended.
Refer to drawing A. Remove the four indicated
screws and lift off the front of the Console. Press two
batteries into the battery holder as shown in drawing
B. Make sure that the negative (Ð) ends of the bat-
teries are touching the springs. Reattach the front of
the Console. Make sure that the three wires are
extending from the back of the Console.
While another person holds the Console (9) near
the Upright (6), connect the two Pulse Wires (22) to
the corresponding wires on the Console. Next, plug
the Extension Wire (18) into the back of the Console.
Attach the ground wire and the Console (9) to the
Upright (6) in the following way:
¥ Peel the backing off one side of the Double-sided
Tape (81). Stick the Tape firmly to the underside of
the Upright (6) so it covers the indicated hole.
¥ Peel the backing off the other side of the Tape (81).
Slide a Star Washer (80) onto a Console Screw
(20) and push the Screw up through the Tape and
the indicated hole. Next, slide another Star Washer
(80) and the ground wire onto the Screw.
¥ Set the Console (9) on the Upright (6) and tighten
the Console Screw (20) into the Console. Then,
tighten three additional Console Screws (20) into
the Console and the Upright.
6. Attach the Cup Holders (14) by firmly pushing them
down into the indicated holes in the Upright (6) until
they are seated fully.
14
14
6
5
6
9
22
80
81
80
Hole
Console
Wires
Ground
Wire
6
20
20
18
4. Attach the Handlebar (16) to the Upright (6) with
three M8 x 45mm Button Screws (17) and three M8
Curved Washers (28). Make sure that the Pulse
Wires (22) are not caught between the Handlebar
and the Upright.
17
28
22
16
6
4
Screws
Batteries
Battery
Holder
B
A