Filter
Top Products
5
ASSEMBLY
Assembly requires two persons. Place all parts of the recumbent cycle in a cleared area and remove the pack-
ing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included tools and your own adjustable wrench .
PART CHART
Use the part drawings below to identify the small parts used in assembly. The number in parenthesis below
each drawing refers to the key number of the part, from the PART LIST on page 14. The second number refers
to the quantity used in assembly. Note: Some small parts may have been pre-attached for shipping. If a
part is not in the parts bag, check to see if it has been pre-assembled.
M8 x 70mm Carriage Bolt (72)Ð2
1/4Ó x 1 1/2Ó Hex Screw (73)Ð4
Console
Screw (20)Ð4
M8 x 45mm Button Screw (17)Ð3
#10 x 5/8Ó
Screw (30)Ð1
5/16Ó Black Flat Washer (57)Ð12
1/4Ó x 5/8Ó Hex Screw (29)Ð4
M8 Nylon Locknut (56)Ð8
M8 Curved Washer (28)Ð7
M5 x 15mm
Screw (69)Ð1
M8 x 80mm Carriage Bolt (63)Ð2
*Zinc M8 x 40mm Carriage Bolt (82)Ð4
#8 x 3/4Ó
Screw (21)Ð1
*The four Zinc M8 x 40mm Carriage Bolts (82) are packaged separately from the other hardware. The
four black M8 x 40mm Carriage Bolts (24) contained in the hardware pack should be discarded.