Filter
Top Products
6
7. Make sure that all parts of the elliptical crosstrainer are properly tightened. Note: Some hardware may
be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical crosstrainer.
6. Refer to the inset drawing. Apply a small amount of the
included lubricant to a paper towel; rub a thin film of
lubricant onto the Chrome Extension Tube (21) on the
Right Pedal Arm (4). Slide the Chrome Extension Tube
into one of the Upper Body Arms (7).
Slide the other Chrome Extension Tube (21) into the
other Upper Body Arm (7) in the same way.
Tap a 5/8Ó Axle Cap (85) onto one end of the Axle (19).
Insert the Axle through one of the Upper Body Arms
(7) and then through the Upright (2). Slide the other
Upper Body Arm (7) onto the Axle. Make sure that the
Upper Body Arms are turned as shown. Tap another
5/8Ó Axle Cap (85) onto the Axle.
19
2
6
21
Lube
4
7
85
7
7
85
5. Connect the Reed Switch Wire (50) to the correspond-
ing wire on the Console (87).
Next, connect the two Pulse Wires (86) to the two
remaining wires on the Console (87). Note: Either
Pulse Wire can be attached to either wire on the
Console.
Next, connect the ground wire to the indicated hole in
the Upright (2) with a Zinc #8 x 1/2Ó Screw (35) and
the #8 Star Washer (53).
Carefully feed the wires down into the Upright (2).
Attach the Console Base (49) to the Upright with four
Zinc #8 x 1/2Ó Screws (35). Be careful to avoid
pinching the wires.
5
86
87
49
35
35
2
50
Console
Wires
35
53
Ground Wire
4. The Console (87) requires two ÒAAÓ batteries (not
included). Alkaline batteries are recommended. To
install batteries, turn the console over and insert two
batteries into the battery clip as shown in the inset
drawing. Make sure that the negative ends of the
batteries (marked ÒÑÓ) are touching the springs in
the battery clip.
Attach a Plastic Tie (90) to the battery clip as shown.
Attach the Console (87) to the Console Base (49) with
four Zinc #8 x 1/2Ó Screws (35), making sure that the
indicated wires are extending from the Console Base
(49). Be careful not to pinch the wires.
4
35
Wires
Battery
Clip
Batteries
87
49
90