Filter
Top Products
7.
Set the console assembly on the Handrail (20).
Be careful to avoid pinching any of the
wires. Make sure that the ground wire (see
step 5) and the wire from the console assem
-
bly (see step 6) are in the indicated channel.
Hand tighten five Screws (3) into the Handrail
(20) and the console assembly. Do not put
Screws into the two indicated holes. Start all
five Screws, but do not tighten them yet.
6. While the second person continues to hold the
console assembly, locate the wire underneath
the console assembly.
Connect the wire from the console assembly to
the Wire Harness (77).
See the inset drawing.
The connectors should slide together easily
and snap into place. If they do not, turn one
connector and then try again. IF THE CONNEC-
TORS ARE NOT CONNECTED PROPERLY,
THE CONSOLE MAY BE DAMAGED WHEN
THE POWER IS TURNED ON. Insert the con-
nectors downward into the Handrail (20).
8
Console Assembly
3
3
No Screws
3
20
77
Console
Assembly
77
20
7
5. While a second person holds the console as-
sembly near the Handrail (20), attach the
g
round wire to the indicated hole in the Handrail
with a Ground Screw (33).
20
H
ole
Ground
Wire
Console
Assembly
33
5
6
Wire
Channel