Filter
Top Products
6
3
89
7
14
Motor
Screw
89
85
85
76
76
3. Slide an M8 Split Washer (85) and an M8 Washer
(89) onto an M8 x 19mm Button Screw (76). Next,
thread the Button Screw into one end of the Incline
Motor Axle (14). With the help of a second person,
raise the Incline Frame (7). Insert the Incline Motor
Axle through one side of the Incline Frame, through
a Plastic Spacer (91), through the end of the motor
screw, through another Plastic Spacer (91), and
through the other side of the Incline Frame.
Slide an M8 Split Washer (85) and an M8 Washer
(89) onto an M8 x 19mm Button Screw (76). Thread
the Button Screw into the open end of the Incline
Motor Axle (14).
Tighten the four M8 x 19mm Button Screws (76)
used in this step and step 2.
1
1. Hold the Rear Stabilizer (4) against the saddle on the
rear of the Frame (1). Make sure that the Rear Stabi-
lizer is turned so the square holes are facing away
from the Frame. Attach the Rear Stabilizer with two
Carriage Bolts (2) and two M10 Nylon Locknuts (55).
2
4
55
55
1
2
7
V-shaped Groove
15
Grease
89
89
76
76
85
85
1
Tubes
Tubes
2. Slide an M8 Split Washer (85) and an M8 Washer
(89) onto an M8 x 19mm Button Screw (76). Thread
the Button Screw into one end of an Incline Axle
(15). Next, apply a small amount of the included
grease to the Incline Axle.
Align the indicated tubes on the Incline Frame (7)
with the tubes on the Base Frame (1). Make sure
that the Incline Frame is turned so the V-shaped
grooves are on top. Insert the Incline Axle (15)
through the Incline Frame and the Base Frame.
Note: It may be helpful to tap the Incline Axle with a
rubber mallet to insert it.
Slide an M8 Split Washer (85) and an M8 Washer (89)
onto another M8 x 19mm Button Screw (76). Thread
the Button Screw into the open end of the Incline
Axle (15). Do not tighten the Button Screws yet.
91