1. With the help of a second person, carefully lay the
treadmill on its right side as shown (refer to the drawing
on page 4 to identify the right side).
Insert the Extension Legs (88) into the treadmill. Make
sure that the Extension Legs are turned so the Base
Pads (70) are on the indicated side. Attach each
Extension Leg with an Extension Leg Screw (83).
With the help of a second person, carefully raise the
treadmill to the upright position so the Extension Legs
(88) are resting flat on the floor.
83
83
88
70
88
70
1
ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver .
3. Insert the brackets on the Console Base (56) into the
Uprights (84); insert any slack in the Wire Harness (54)
into the right Upright. Thread four Handrail Bolts (48)
with Handrail Washers (47) into the Uprights. Tighten
all four Handrail Bolts.
Make sure that the two indicated Grommets (89) are
pressed into the holes.
2. Refer to HOW TO LOWER THE TREADMILL FOR USE
on page 11. Follow the instructions on page 11 to lower
the treadmill.
Next, remove the nut, bolt, and shipping bracket from
the left Upright (84).
47
48
84
48
54
89
89
47
56
Bracket
Bracket
3
Bolt
Nut
Shipping
Bracket
84
2
5