Filter
Top Products
To Install Batteries
To begin playing with
ICAT,
you mu* first install the batteries.
Using a Phillips/cross head screwdriver, loosen xrew in battery
i
compartment cover (xrew stays attached to cover) on the center
of
its
tummy. Insert
2
x
1.5V
"AA"
or
LR6
size alkaline batteries
(not included). Insert the second battery into the compartment
cover. Replace cover and tighten screw.
CAUTION: TO AVOID BATTERY LEAKAGE
1.
Be sure to insert the batteries correctly and always follow
the toy and battery manufacturers' instructions;
2.
Do not mix
old
and new batteries or alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium) batteries;
3.
Always remove weak or dead batteries from
the product.
IMPORTANT: BATTERY INFOKMJTION
Please retain this information for future reference.
Batteries should be replaced by an adult.
CAUTION:
1.
Always follow the instructions carefully. Use only batteries specified and be
sure to insert item correctly by matching the
+
and
-
polarity markings.
2.
Do not mix old and new batteries or standard (carbon-zinc) with alkaline
batteries.
3.
Remove exhausted or dead batteries from the product.
4.
Remove batteries if product is not to
be
played with for a long time.
5.
Do not short-circuit the supply terminals.
6.
Should this product cause, or
be
affected by, local electrical interference,
move
it
away from other electrical equipment. Reset (switching off and back
on again or removing and re-inserting batteries) if necessary.
7.
RECHARGEABLE BATTERIES: Do not mix these with any other types of
batteries. Always remove from the product before recharging. Recharge
batteries under adult supervision. DO NOT RECHARGE OTHER TYPES
OF BATTERIES.
4