Filter
Top Products
SKU 1102 For technical questions, please call 1-800-444-3353. Page 4
Air source
a. Never connect to an air
source that is capable of
exceeding 90 PSI. Over
pressurizing the tool may
cause bursting, abnormal operation,
breakage of the tool or serious injury
to persons. Use only clean, dry,
regulated compressed air at the rated
pressure or within the rated pressure
range as marked on the tool. Always
verify prior to using the tool that the
air source has been adjusted to the
rated air pressure or within the rated
air-pressure range.
b. Never use oxygen, carbon dioxide,
combustible gases or any bottled
gas as an air source for the tool.
Such gases are capable of explosion
and serious injury to persons.
SAVE THESE
INSTRUCTIONS.
Specic Safety Instructions
1. The warnings and precautions dis-
cussed in this manual cannot cover
all possible conditions and situations
that may occur. It must be under-
stood by the operator that common
sense and caution are factors which
cannot be built into this product, but
must be supplied by the operator.
2. Do not use with bottled gases.
3. Always keep Sealing Gasket (3) in
place.
4. Check all local laws regarding use.
5. Do not puncture or incinerate Spray
Can.
6. Do not use with corrosive products.
7. A tire chuck (not included) must be
attached to the air supply hose in
order to pressurize Spray Can.
8. Do not expose to heat or store at
temperature above 120° F.
9. Obey the manual for the hand pump
and the compressor used to power
this tool.
10. Flush the system with pressurized
clean water after use with liquids
other than water.
11. Do not overll the Spray Can. It
holds 16 uid ounces (max. lled
liquid should not exceed 8 uid ounc-
es.)
12. Read warnings of uids and applica-
tions used with Spray Can. Adhere to
all safety warnings concerning han-
dling of applications.
13. DO NOT spray up wind.
14. Before storing, discharge contents,
ush with clean water, and wash
and dry exterior. Then store in a safe
place out of reach of children.
SAVE THESE
INSTRUCTIONS.