Filter
Top Products
750000-INS-LAB-RevC11 17
Fuse replacement
tool needed: small screwdriver
1. If you suspect a blown fuse,
disconnect the plug from the
wall outlet immediately.
2. Use a small screwdriver to
remove the cover of the fuse
holder (fuse locations are shown
in picture at right).
3. Insert a new fuse of the correct
rating (T1A/250V, VDE approved).
4. Replace the fuse holder cover.
Air lter replacement
1. Remove the air lter plate
located at rear of pump (lter
location shown in picture at
right).
2. Remove the lter. The lter is
reusable, if not torn, and can
be washed gently with a mild
detergent and water. Dry the
lter before use.
3. Replace the air lter regularly if it is gray, torn, or the
environment is dirty.
STORAGE
1. Lay the mattress out at and upside down.
2. Roll from the head end toward the foot end.
3. Stretch the foot-end strap around the rolled mattress to
prevent unrolling.
4. Store mattress and pump in a dust-free environment
with no exposure to direct sunlight.
s NOTICE:Donotfold,creaseorstackthemattress.