Filter
Top Products
5
ASSEMBLY
To hire an authorized service technician to assemble the elliptical exerciser, call 1-800-445-2480.
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the
included hex keys, assembly requires a Phillips screwdriver , an adjustable
wrench , and a rubber mallet .
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parenthe-
ses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The
number following the parentheses is the quantity needed for assembly. Note: Some small parts may have
been preassembled. If a part is not in the hardware kit, check to see if it has been preassembled.
M8 Split
Washer (72)–2
M4 x 16mm
Self-tapping
Screw (79)–10
M8 x 42mm Bolt
(71)–4
M10 x 20mm x
1mm Washer
(81)–2
M4 x 16mm
Screw (86)–4
M10 Spacer
(76)–2
M6 x 35mm Phillips
Screw (87)–8
M6 Split
Washer (88)–8
M10 x 23mm Shoulder
Screw (80)–2
M4 x 13mm
Washer (93)–2
M10 x 25mm
Washer
(94)–10
M8 Nylon
Locknut (96)–4
M10 Nylon
Locknut (97)–2
Star Washer
(92)–3
M10 x 20mm Patch
Screw (91)–10
Wave Washer
(98)–8
M8 x 16mm Patch
Screw (95)–3
M8 x 48mm Patch
Screw (78)–2
M10 x 62mm Patch Bolt (89)–4 M10 x 78mm Patch Screw (90)–2