Filter
Top Products
8
5. Raise the Uprights (31, 36) so that the Base (48)
is flat on the floor and positioned as shown.
Cut the tie holding the Upright Wire (28) in a bun-
d
le.
See the far right drawing. Wrap the wire tie in the
Right Upright (36) around the end of the Upright
W
ire (28). Then, pull the other end of the wire tie
until the Wire Harness is extending from the
upper end of the Right Upright.
Make sure that the end of the Upright Wire
(28) does not fall into the Right Upright (36).
5
28
Wire Tie
48
28
36
3
1
Large
Hole
Wire
Tie
6. Raise the Uprights (31, 36).
See the left inset drawing. Identify the two
Frame Spacers (34). Open the included packet
of grease, and apply grease to both sides of both
Frame Spacers. Then, identify the outer side of
each Frame Spacer.
Hold the Frame Spacer (34) between the Right
Upright (36) and the Lift Frame (59), with the
outer side of the Frame Spacer facing the
Right Upright. Attach the Right Upright to the
Lift Frame with a 3/8" x 3" Bolt (32), a 3/8" Flat
Washer (33), and a 3/8" Locknut (47); do not
fully tighten the Bolt yet.
6
31
36
32
32
34
34
33
47
47
59
33
59
Outer
Side
Inner
Side
34
36
Top View